Welcome To b2b168.com, Join Free | Sign In
中文(简体) |
中文(繁體) |
Francés |Español |Deutsch |
| No.13327223
- Product Categories
- Friendly Links
Information Name: | Long-span bridge with a rubber bearing rubber bearing manufacturer in Hohhot |
Published: | 2014-09-03 |
Validity: | 300 |
Specifications: | |
Quantity: | 5000.00 |
Price Description: | |
Detailed Product Description: | Railway bridge rubber bearing basin referred to as: TBZB pot bearings. This is a specially designed for the manufacture of railway girder pot rubber bearing products, it is designed to meet the existing railway running standard design concrete, prestressed concrete beam (beam fragmentation, the entire hole beam, girder, under Order Beam) and the design of the "standard bridge bearings." Is a non-earthquake zone stand that can be used on a straight, flat slope, curves and ramps lines. The check bearing screw hole diameter, spacing consistent with the standard design of the beam, in order to be used with steel bearings are interchangeable. The following applies to the eight seismic (including eight degrees) and the flexible use of railway bridge piers. TPZB pot rubber bearing product installation instructions: A, when using TPZ standard series rubber bearing basin, Bridge Beams and stone pier platform supporting part concrete pad should not be less than C40 grade level. Special circumstances shall consult with the design unit. Highly branched stone cushion should consider the possibility of replacing the roof beams when support. The height of the supporting pad stone is generally 30-50cm. Concrete B, anchor bolt, and in part by the support pad stone norms set steel mesh. C, elevation bearing installation shall comply with the design requirements, to ensure that both the horizontal plane bearing, bearing support surface height not greater than the four corners of 2mm. D, the bearing piers using anchor bolts and connections should be adopted at the pier top bolt hole reserved approach to anchoring bolt. Can also be used when necessary embedded steel welded connections, welding steel to prevent bearing overheating, it would burn rubber, PTFE plate, 295 grease. Before E, beam erection, rubber bearing basin can be installed on the beam. |
Admin>>>
You are the 6945 visitor
Copyright © GuangDong ICP No. 10089450, Run-up Engineering Rubber Co., Ltd. Hengshui All rights reserved.
Technical support: ShenZhen AllWays Technology Development Co., Ltd.
AllSources Network's Disclaimer: The legitimacy of the enterprise information does not undertake any guarantee responsibility
You are the 6945 visitor
Copyright © GuangDong ICP No. 10089450, Run-up Engineering Rubber Co., Ltd. Hengshui All rights reserved.
Technical support: ShenZhen AllWays Technology Development Co., Ltd.
AllSources Network's Disclaimer: The legitimacy of the enterprise information does not undertake any guarantee responsibility